You have 0 items in your cart.
By Brands
Brands
Sub Categories
Category:
Power Meter
Simultaneous Power & Power quality measurementsPower/ Harmonics/ Waveform/ Power quality are recorded at all CHs. (Voltage: 3ch, Current 4ch) • Helpful support functionsQuick Start Guide, Wiring check and Sensor detection for easy and reliable measurement • Measurement with high accuracy Guaranteed accuracy: ±0.3%rdg (energy),±0.2%rdg (voltage/ current) Complies with the International Standard IEC 61000-4-30 Class Sand the European Standard EN50160 • Remote monitoring on PC and Android deviceRemote checking of measurement in real-time is possible via Bluetooth communication.Recorded data can be saved in the supplied SD card.EN50160 report can be generated after survey by PC software.
Category:
Power Meter
Comprehensive real-time monitoring, recording and analysis of single and 3-phase systems • Voltage, Current, Power Factor and Frequency measurements • Power analysis (Active, Apparent and Reactive power) • Energy analysis (Active, Apparent and Reactive power) • Active power accuracy: ±0.3%rdg±0.2%f.s. • Automatic wiring check function to prevent incorrect connections • Large memory capability (2GB) using built-in SD card interface • Real time & remote measurements using Android application • synchronous measurements between two units of KEW 6305 • Wide selection of clamp sensors allow measurements from 0.1A to 3000A • The instrument automatically recognizes what kind of clamp sensor is connected to it
Category:
Sensors, Multi-Trans, Clamp adaptors
Multi-Trans How to Use Clamp your instrument around the pick-up coil of the multi-tran. Then, clamp the transformer jaws of the multi-tran on the conductor, as shown below. Multiply the reading of your clamp meter by 10 to obtain the current value measured.
Category:
Sensors, Multi-Trans, Clamp adaptors
AC/DC CLAMP ADAPTOR • Model 8113 is a clamp-on AC/DC current/voltage converter that permits AC/DC current measurements from 1mA to 200A in conjunction with a voltmeter having 0.1mV resolution.
Category:
Sensors, Multi-Trans, Clamp adaptors
AC CLAMP ADAPTOR Model 8112BNC is an AC clamp adaptor designed for use with oscilloscopes. Output cord has a BNC connector which enables direct observation of current waveform on oscilloscope. Refer to a diagram shown at left for application. Specifications are same as those for Model 8112.
Category:
Sensors, Multi-Trans, Clamp adaptors
AC CLAMP ADAPTOR • Model 8112 clamp adaptor is designed to be an AC current/voltage conversion probe capable of measuring AC current from 0.1mA to 120A in conjunction with digital multimeters. Simple to operate, the unit has range switch position at 200mA,2A and 20A. It also features safety design throughout with no exposed metal parts.
Category:
Sensors, Multi-Trans, Clamp adaptors
AC CLAMP ADAPTOR • Model 8006 is designed to measure AC current up to1500A. • It can accommodate up to 60mm-dia conductor or 50mm by 75mm bus-bar.
Category:
Sensors, Multi-Trans, Clamp adaptors
Permits extension of the AC and DC current ranges of almost any Digital Multimeters (DMMs) without breaking the circuit under test. • Using KEW 8115 with KEW 1051/1052 (DMM) the display can be set for direct reading in A.